visable.png

Skip header
 

Scan Position

You can move the scanning position of originals.

Illustration of Scan Position

  1. Point from which the machine begins scanning

You can move the scanning position up to 30 mm (1.2 inches) in 1 mm (0.1 inch) increments upward, downward, to left and to right.

Illustration of Scan Position

  1. Top: 0 - 30 mm, 0 - 1.2 inches

  2. Right: 0 - 30 mm, 0 - 1.2 inches

  3. Bottom: 0 - 30 mm, 0 - 1.2 inches

  4. Left: 0 - 30 mm, 0 - 1.2 inches

1Press [Edit / Stamp].

Operation panel screen illustration

2Press [Scan Position].

3Specify the scanning position for the front side of the original.

Operation panel screen illustration

4Specify the scanning position for the back side of the original. Then press [OK].

If you don't need to set the scanned position of the back side of the original, press [OK].

Note

  • To change the value you entered, press [], [], [] or [], or press [Clear], and then specify a new value.

  • Press [] and [] to set the top or bottom position. Press [] and [] to set the left or right position.

  • The scanning position for the back side of the original is valid only when you are copying 2-sided originals.