   |  |  | |
 | |||
 | |||
 |  |  |  |
 |   Manuals Contents Previous Next |   | |
You can move the scanning position of originals.
Point from which the machine begins scanning
You can move the scanning position up to 30 mm (1.2 inches) in 1 mm (0.1 inch) increments upward, downward, to left and to right.
Top: 0 - 30 mm, 0 - 1.2 inches
Right: 0 - 30 mm, 0 - 1.2 inches
Bottom: 0 - 30 mm, 0 - 1.2 inches
Left: 0 - 30 mm, 0 - 1.2 inches
Press [Edit / Stamp].
Press [Scan Position].
Specify the scanning position for the front side of the original.
Specify the scanning position for the back side of the original. Then press [OK].
If you don't need to set the scanned position of the back side of the original, press [OK].
To change the value you entered, press [
], [
], [
] or [
], or press [Clear], and then specify a new value.
Press [] and [] to set the top or bottom position. Press [] and [] to set the left or right position.
The scanning position for the back side of the original is valid only when you are copying 2-sided originals.
 |
 | Copyright (C) 2009 |
