visable.png

Skip header
 

Before the Transmission Is Started

Use this procedure to cancel a transmission after the original is scanned.

This function is useful to cancel a transmission when you notice a mistake in destination or with the originals after storing. To cancel Memory Transmission, search for the file to be canceled among the files stored in memory, and then delete it.

You can cancel transmission of a file while the file is being sent, stored in memory, or fails to transmit. All the scanned data is deleted from memory.

Important

  • This function is unavailable with Immediate Transmission.

1Press [Change TX / Info].

Operation panel screen illustration

2Press [Check / Stop Transmission File].

Operation panel screen illustration

The list of stored files being transmitted or waiting for transmission appears.

To display only the files being sent, press [Files under TX].

3Select the file you want to cancel.

Operation panel screen illustration

If the desired file is not shown, press [Up arrow key] or [Down arrow key] to find it.

There are cases when a destination may not be selected as the destination appears as “Asterisk”, depending on the security settings.

4Press [Stop Transmission].

Operation panel screen illustration

5Press [OK].

Operation panel screen illustration

To cancel another file, repeat steps 3 through 5.

To cancel stopping transmission, press [Cancel].

6Press [Exit] twice.

Operation panel screen illustration

The standby display appears.

Note

  • To delete some destinations from a broadcast, see “Deleting a Destination from a Broadcast”.

  • If you cancel a transmission while the file is being sent, some pages of your file may have already been sent and is received at the other end.

  • If the transmission finishes while you are carrying out this procedure, transmission cannot be canceled.

  • If multiple destinations were specified, only the number of the destinations that have not received the document you sent is shown.

  • If multiple destinations were specified, only one destination number appears. To display all destinations, press [Check / Change Settings].