Loading Paper into the Interposer

This section describes how to load paper into the interposer.

Load paper on the side already printed (the front side). If you are using the Finisher SR4040, load sheets print side down.
Load paper in the interposer in the same orientation as paper in the paper tray.
The staple or punching location will be on the left side of the paper, when you are facing the machine.
Do not place anything on top of or leave documents on the sensor. This may lead to the paper size not being correctly scanned or paper jams.
When using the folding functions, the paper in the interposer must be of the same size as the prints after they have been folded. If the paper in the interposer is larger than the folded sheets, a misfeed might occur.
Do not stack paper over the limit mark.
Do not use paper that has already been printed onto by this machine.

The tray can hold up to 200 sheets of paper.
To set the paper in the interposer, align the orientation of originals in the ADF as shown below.