visable.png

Skip header
 

Finisher SR4030 / SR4040

The following procedure describes how to remove punch waste from the Finisher SR4030 and Finisher SR4040.

Note

  • While “Hole Punch Receptacle is full.” is displayed, you cannot use the Punch function.

  • “Hole Punch Receptacle is full.” is displayed until the punch waste box is reinstalled.

  • If the message is still displayed, reinstall the punch waste box.

1Open the finisher front cover.

Finisher illustration

2Pull out the punch waste box carefully, and then remove punch waste.

Punch waste box illustration

3Reinstall the punch waste box.

Punch waste box illustration

4Close the finisher front cover.

“Hole Punch Receptacle is full.” disappears.